Each kit includes anodized aluminum tubing. One end is loose so you can cut tubing to desired over-all length and then fasten end fitting with epoxy supplied. Less than 10 minutes to complete.
Mini 6'/7' kits include nylon latching end fittings, nylon lanyard, pad eye and epoxy kit.
See also: Size Recommendation Guide by length or boat model, Spinnaker poles, and End Fittings.
Our standard spinnaker poles have a double bridle topping lift/foreguy system. Unless otherwise specified, all standard poles are supplied with the throat (jaw) facing upward.
Fresh Water Rinse
ABOUT THE CARE OF FITTINGS
Yachtsmen take particular care when painting or varnishing their hulls, looking after sails, spars and rigging, and then, for the most part, forget to maintain their poles, valves and deck fittings. The most effective method of keeping deck hardware (e.g. pole ends, cams etc.) working freely is to wash them thoroughly with fresh water after every race or cruise. This is especially important when using spinnaker/whisker poles, tiller extensions or other telescoping equipment. Salt and sand that is not cleaned out can destroy the locks, cams, springs or rollers in a matter of months. Forespar® strongly advises against the use of lubricants on pole ends and telescoping poles. This can clog spring housing and ball bearings and can destroy twist-lock components. As a general rule, all fittings on deck, whether a dinghy or an ocean racer, should be maintained regularly. As previously mentioned, the best treatment is fresh water washing/flushing. This attention to maintenance will ensure that every fitting on your yacht will function at its best and attain a maximum performance life.
CALL FORESPAR
Enter Your Email Address to Get our eNewsletter
